Dealer Calibration - Raymarine ST40 Owner's Handbook Manual

Chapter 4: Calibration
4.3 Intermediate calibration

4.4 Dealer calibration

Intermediate calibration enables you to:
• Check the instrument software version.
• Check the instrument status - either master (shown as RPTR NO) or
repeater (shown as RPTR YES).
You cannot make any adjustments in Intermediate calibration.
Follow the procedure in the Intermediate calibration flow diagram.
INTERMEDIATE CALIBRATION
hold down
Software
version
Instrument
status
To return to normal operation from either screen,
hold down
Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
During normal operation
and
for approximately 4 seconds
ST40 COMPASS
CAL
ST40 COMPASS
and for approximately 2 seconds
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
25
D4781-2