Changing Built-In Fuse - Profoto D1 1000 Air User Manual

changing built-in fuse

1. Ensure that the D1 unit is turned off and that the power cable is not connected.
2. If the unit has been in use, wait five minutes to allow the unit to be fully discharged (the
autodump function).
3. Pull out the Fuse Holder [14] from the unit and remove the old fuse.
4. Push the new fuse all the way into the Fuse Holder. Only use recommended fuse, see
section Technical data.
5. Fit the Fuse Holder in place, by gently pushing until the holder snaps in place.
18
www.profoto.com