Profoto D1 500 Air Quick Start Manual

Most of our flash heads are hanging on the ceiling, so this is how you will see their displays: upside down
Turn on the flash head
1 (you can also use the H
Turn off after use
Check Channel and Group (only when using Profoto remote control):
The number and letter in the display must correspond with the ones on the label
2
If not: turn the setting knob (7) to set the channel (numbers 1 to 6)
push and turn the setting knob to set the group (A or b)
3 Set Modelling light to
4 Set Ready indicator to
Set the Slave function:
5 RADIO: the flash will respond to the Profoto Remote Control
IR : the flash will be triggered by another flash or an IR remote control
Do not change this setting
6
The value should always be
Use the Setting knob to adjust the flash value:
7 Turn for small increments
Push and turn for large increments
Mandatory settings in
Big Studio Quick Start Guide
button on the remote control)
EAD
PROP (proportional)
BEEP
10
red, Recommended settings in blue