Table of Contents
Advertisement
19.BOOM INSTALLATION
Push gooseneck pin through mast and fasten
main furling handle with clevis pin and ring.
(FIGURE 36)
Attach topping lift wire to outboard end of
boom.
20.MAINSHEET ATTACHMENT
20.1 Attach the main sheet system as shown.
Tie off the traveler line end (B) with a figure-
eight knot. (FIGURE 37)
FIGURE 36
FIGURE 37
20.2 Move and secure the traveller car to the
left side of the boat. Using the mainsheet,
sheet in tight. Now tighten the left shroud by
moving it down two or three holes in the
adjuster. Secure the shroud with a clevis pin
and ring. (FIGURE 38)
20.3 Release the tension on the mainsheet
and move the traveller to the right side. Repeat
to tighten the right shroud.
20.4 Release the tension on the mainsheet
when the tightening procedure is finished and
return the boom to its normal position.
NOTE: Whenever the boat is set up,
tightening will be required to achieve proper
shroud tension.
17
FIGURE 38
Advertisement
Table of Contents
