Garland G Series Technical Reference Manual page 41

3. Remove the gas lines from the valve. You will also need
to remove the fittings from the valve.
4. Remove the two nuts and bolts that hold the thermostat
in place. (Do not lose)
5. Remove the thermostat
To install a new thermostat:
1. Ensure that the fittings removed from the housing are
installed in the same location where they were found on
the control that is being replaced
2. Reverse the process listed above, ensuring that the
proper sequence of installation is followed:
A. Install left side first before the gas inlet tubing.
B. Observe overlap.
Part # GCTRM Rev 3 (12/10/09)
C. Observe capillary and T couple routing
Page 41