Installation Procedure; Unpacking The System Unit - Fujitsu PRIMERGY BX400 S1 Operating Manual

Installing the hardware
4.1

Installation procedure

The following installation steps are described in detail in the following sections
of this chapter:
Unpacking the system unit (see
●
Installing the system unit in the rack (see
●
unit" on page 46
the floorstand model (see
page 45).
Connecting the cables of the system unit (see
●
read the section "Instructions for connecting/disconnecting cables" on
page 58.
Connecting the system unit to the mains (see
●
to the mains" on page
4.2

Unpacking the system unit

V
CAUTION!
Follow the safety instructions in chapter
The system unit must always be lifted or carried by at least two people.
(For the Japanese market, please refer to " 安全上のご注意 ".)
Do not unpack the system unit until it is at its installation location.
Ê Transport the system unit to the place where you want to set it up.
Ê Unpack all individual parts.
Keep the original packaging in case you want to transport the system unit
again (applies only to EMEA market).
Ê Check the delivery for any damage during transport.
Ê Check whether the items delivered match the details on the delivery note.
The product name and serial number of the product can be found on the ID card
(see section 5.1.1.3 on page
Ê Notify your supplier immediately should you discover that the items
delivered do not correspond to the delivery note.
44
"Unpacking the system unit" on page
and configuration diagram on the order lists) or setting up
section "Setting up the floorstand model" on
55).
64).
Operating Manual
"Installing/removing the system
4.5 on page 53). Please also
"Connecting the system unit
"Important notes" on page
44).
31.
BX400 S1