Table of Contents
Advertisement
Diagram 13
page 16
5.
Remove the paper to expose the adhesive strip that is on
the foam mounting pad. Press the reed switch onto the
pad. Be sure that the reed switch is positioned so that the
wires are easily routed up the handrail. See Diagram 13.
6.
Rotate the flywheel by hand to make sure that the magnet
and reed switch are secure and are not rubbing on each
other or on the treadmill. Check that the reed switch wire is
clear of the flywheel. If the magnet and flywheel are not
correctly aligned you may get incorrect readings on the
display. Reposition the magnet and reed switch if
necessary.
7.
Secure the handrails into an upright position.
8.
Check the wires to be sure no excessive amount of
wire hangs down where it could cause entrapment or
injury to someone. Realign the wire and move the C
clips along the handrail if necessary.
9.
DO NOT OPERATE the treadmill for a 24-hour period.
The adhesive on the mounting pads requires this
amount of time to bond properly.
Advertisement
Table of Contents
