4
Pegs
Remote
Controller
Holder
• "Snap" the remote controller
holder onto the tab on the bottom
of the starting ramp, as shown.
• Insert and "snap" the pegs on
the bottom of the handle
assembly into the matching holes
in the starting ramp as shown.
Assembly
Handle
Assembly
Starting
Ramp
Tab
7
5
Control
Tower
Handle
• Insert the handle and starting
ramp into the matching holes in
the control tower as shown.
• Lift the control tower storage
compartment door. Insert two
screws through the control tower
and into the handle. Tighten the
screws with a Phillips screwdriver.
Do not over-tighten.
• Insert two screws through the
holes near the bottom of the
control tower and into the pegs in
the starting ramp. Tighten the
screws with a Phillips screwdriver.
Do not over-tighten.
Starting
Ramp