Table of Contents
Advertisement
TROUBLESHOOTING
GUIDE
If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR,
locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE
ACTION columns to remedy the problem.
SYIVI/'TOM
No power.
No picture and sound.
No picture or poor picture
on TV/VCR.
No sound or poor sound.
Timer recording is not
possible.
Cannot go into Record
mode.
Playback picture is
partially noisy.
Noise in picture on
playback.
No operation by infrared
No power to TV/VCR.
Remote Control.
Weak batteries.
POSSIBLE CAUSE
AC Power cord is not connected.
Power is off.
TV/VCR is not plugged into an active
AC outlet.
Antenna is not connected.
No channel in memory.
Direction or condition of antenna is not
adequate.
Picture control is not adequate.
Volume control on remote control unit
or main unit is in minimum position.
MUTE button on the remote control
unit is in the ON position.
The timer recording is set incorrectly.
The timer recording is not set to ON.
The erase-prevention tab on cassette is
missing.
The TRACKING control is not set
correctly.
Video heads are dirty.
Q
4
CORRECTIVE
ACTION
Connect AC power cord to AC outlet.
Press POWER button to turn on the
TV/VCR.
Plug power cord into an active AC outlet.
Check antenna connection.
Program tuner's memory.
Adjust direction or replace antenna.
Adjust picture controls.
Adjust volume control on remote control
unit or set.
Press MUTE button.
Set the timer recording correctly.
Set the timer recording to ON.
Place transparent tape over missing erase-
prevention tab.
Adjust TRACKING control for better
picture.
Head cleaning is necessary, consult the
nearest Sears Service Center.
Make sure the AC cord is connected to an
AC outlet.
Check the batteries in the Remote Control.
- 34 -
EN
****_
5D20
I
B560TI'RB
Advertisement
Table of Contents
