Cycles - Whirlpool Cabrio WGD6600VU0 Use & Care Manual

If you wish to adjust the cycle length of a Timed Cycle,
press the Time Adjust up or down arrows. Adjust the
temperature of a Timed Cycle by pressing Temp until the
desired temperature is selected.
NOTE: You cannot choose a dryness level with Timed
Cycles.
Follow the progress of your dryer with the drying Status indicator
lights.
Cool Wrinkle
Select the drying cycle that matches the type of load you are
drying. See the Automatic or Steam Preset Cycle Settings
Charts.
CASUAL
DELICATE
Sensing
• In an Automatic Cycle, the Sensing light illuminates until a
wet item is detected.
• In theTimed Dry Cycle, the Sensing light illuminates at the
beginning of a cycle and turns off 5 minutes into the cycle.
Wet
The Wet light illuminates at the beginning of an Automatic Cycle if
a wet item is detected.
In an Automatic Cycle, if a wet item is not detected after
approximately 5 minutes, the dryer goes directly into Cool
Down and the Cool Down and the WRINKLE SHIELD
TM
setting indicators illuminate, if selected.
• In a Timed Cycle, wet items are not detected. The dryer will
continue to run for the length of time selected, and the Wet
light will illuminate. The damp light will not illuminate.
In the Enhanced Touch Up and Quick Refresh Steam Cycles,
the Wet light comes on after the water has been sprayed into
the drum, 5-6 minutes into the cycle. The wet light illuminates
until the dryer goes into Cool Down, with 1 minute of time
remaining.
Damp
The Damp light illuminates in an Automatic Cycle when the
laundry is approximately 80% dry. Damp Dry Signal beeps, if
selected. See "Options."
Cool Down
The Cool Down light illuminates during the cool down part of the
cycle. Laundry cools for ease in handling.
Done
The Done light illuminates when the drying cycle is finished. This
TM
indicator stays on during the WRINKLE SHIELD setting.
WRINKLE SHIELD
TM
Setting
The WRINKLE SHIELD
TM
setting light illuminates when this
option is selected. This indicator stays on during the WRINKLE
SHIELD
TM
setting.
Indicator lights
Other indicator lights show Cycle, Modifiers, Options and Cycle
Signal settings selected. The display shows the estimated or
actual time remaining.
TIMED qUICK ENHANCED
DRY REERESN TOUCHUP
Automatic Cycles
Automatic Cycles allow you to match the cycle to the load you
are drying. See the following Automatic Preset Cycle Settings
chart. Each cycle dries certain fabrics at the recommended
temperature. A sensor detects the moisture in the load and
automatically adjusts the drying time for optimal drying.
Heavy Duty
Use this cycle to get high heat for heavyweight =-nixedloads,
cottons and jeans.
Normal
Usethis cycle to get medium heat for drying sturdy fabrics such
as work clothes.
Casual
Use this cycle to get low heat for drying no-iron fabrics, such as
sport shirts, casual business clothes and permanent press
blends.
Delicate
Use this cycle to get extra-low heat to gently dry items such as
lingerie, blouses or washable knit fabrics.
Automatic Preset Cycle Settings
Automatic Cycles Temperature
Load Type
HEAVY DUTY High
Heavyweight mixed loads, cottons,
jeans
NORMAL Medium
Corduroys, work clothes
CASUAL Low
Business casual clothes, permanent
press, synthetics
DELICATE Extra-Low
Lingerie, blouses, washable knit
fabrics
16