Weider PowerGym 15601 Owner's Manual page 19

[]
[]
[]
Bring the Cable back down
across the top of the Top Frame
and through the welded Pulley
Bracket. Insert the entire Cable
down through the Cable access
hole located behind the Welded
Bracket.
Fit the Cable over a 3 112"
PULLEY (51) and bolt into the
Welded Bracket. Secure with a
3/8" X 1 314" HEX HEAD BOLT
(73) and a 318" NYLON LOCK
NUT (79).
Leave some of the Cable draped
down between the Guide Rods,
This area of the Cable will be
assembled later, The amount of
the Cable left draped is not
critical as you will be pulling the
slack out of the Cable once the
Cable is fastened.
[]
[]
[]
Move to the left-hand Side of
the unit.
Bring the PEC.DECK CABLE
(37) up and set into a 3 112"
PULLEY (51).
Trap the Cable into the groove
of the Pulley using a CABLE
TRAP BRACKET (42) (THE
CABLE TRAP BRACKET
WILL BE POSITIONED AT
APPROXIMATELY A 45
DEGREE ANGLE) and bolt
assembly to the PULLEY
BRACKET (29) that is bolted
to the bracket on the side of
the Top Frame using a 3/8" X
1 3/4" HEX HEAD BOLT (73)
and a 3/8" NYLON LOCK NUT
(79).
._°:
PAGE 18 WELDER SPORT1NG GOODS
WELDED PULLEY 57
_7
8
51
8 73 42
I \
51
37