List Of Wlan Setting Items - Pioneer XDJ-AERO Operating Instructions Manual

List of WLAN SETTING items

When [MODE] at [WLAN SETTING] is set to [OFF], only [MODE] and [RESET TO DEFAULT] are displayed.
Setting item 1
MODE
1
INPUT WPS PINCODE
1
NETWORK SETTING
1
OTHERS
RESET TO DEFAULT
2
SELECT SSID
2
DHCP CLIENT
IP ADDRESS/SUBNET MASK
*: Setting upon purchase
1 Not displayed in the WLAN client mode.
2 Items marked "**" are not displayed in the access point (AP) mode.
28
En
Setting item 2 Setting ranges
OFF/ACCESS POINT(AP)*/
—
WLAN CLIENT
— 0 to 9 (max. 8 characters)
A to Z, a to z, 0 to 9, symbols
SSID
(max. 32 characters)
SECURITY OPEN / WPA / WPA2
A to Z, a to z, 0 to 9, symbols
PASSWORD
(max. 64 characters)
IP ADDRESS
SUBNET MASK
CHANNEL NO. CH1～AUTO*
DHCP SERVER ENABLE*/DISABLE
CHANNEL WIDTH 20 MHz*/40 MHz
0minute to 60minute* to
KEY RENEWAL INTERVAL
1440minute
— YES/NO*
Method of selection + input
—
method
—
ENABLE*/DISABLE
000:000:000:000 to
255:255:255:255
—
(Set to 192:168:1:1/255:255:255:0
upon purchase.)
Description
Used to set this unit's operation mode.
When in the access point mode, input the PIN code of the sub unit
to be connected to this unit here to authorize connection.
Used to set this unit's [SSID].
Used to set this unit's security (encryption) type.
Used to set this unit's password.
Sets this unit's IP address.
Sets this unit's subnet mask.
This unit uses the 2.4 GHz band. If there is a wireless LAN network
on the same band in the area and the waves cause interference,
making connections and communications instable, try changing
the channel manually. (By default, this is set to [AUTO] and a
relatively free channel is selected automatically.）
Used to set whether or not to enable this unit's DHCP server
function.
[ENABLE]: Enables the DHCP server function.
[DISABLE]: Disables the DHCP server function.
Used to set the frequency band's width.
Only set [40 MHz] when communications are possible by
IEEE802.11n. Otherwise leave this at [20 MHz].
When [WPA] or [WPA2] is set at [SECURITY] under [NETWORK
SETTING], the encryption key's renewal interval can be set.
When this setting is made, the encryption key is renewed automati-
cally at specific intervals, maintaining a more secure status.
Resets the settings at [WLAN SETTING] to the factory defaults.
Displays up to 10 receivable networks (SSIDs) in the area. "OTHER"
at the bottom is used to specify an [SSID] that is not displayed.
Used to select whether to acquire the network settings automati-
cally using the DHCP function on the connected network side or to
set them manually.
[ENABLE]: Acquire the IP address, subnet mask, etc., automatically.
[DISABLE]: Input the IP address, subnet mask, etc., manually.
When in the access point mode, the fixed values below are set.
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
When [DHCP CLIENT] is set to [DISABLE], the values must be input
manually.