Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba CZ36V61 Owner's Manual

To select the antenna input:
1. Press the ANT/VIDEO button. The signal source you are
connected to is displayed in purple.
2. Press the button until ANT 1 or ANT 2 is displayed in purple,
indicating the antenna terminal you wish to use.
Adding channels to the TV's memory
Your TV will stop on specific channels that are stored in the TV's
channel memory when you press Channel • or v. Use the steps below
to set all active channels in your area automatically.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory, you
can erase channels or add your favorite channels. If you use both
ANT-I and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press • or • to highlight the SET UP menu.
2. Press • or • until the TV/CABLE selection is highlighted.
3. Press • or • to highlight either TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press • to select CH PROGRAM.
5. Press • or • to start channel programming. The TV will automati-
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the
channel memory.
While the TV is cycling through the channels, the message
"Programming Now Please Wait" appears.
6. When channel programming is complete, the message "Com-
pleted (channel or cable number)" appears.
7. Press Channel • or • to view the programmed channels.
13
I
Ant/Video
Note:
Video 3 is only available on model
CZ36V6L
Menu/Enter
V& <_"
Exit
Q
g
m
I