Table of Contents
Advertisement
12
12
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to Section 16.
WARNING
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result in
a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used safely.
D. Lava Rock and Ember Placement
WARNING
Explosion Risk.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Placing the Lava Rock
Place the lava rock on the bottom of the fi rebox. Evenly
spread the lava rocks with your hand.
36
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports.
• When placing Glowing Embers
• Save the remaining ember materials for use during appli-
Heat & Glo • Bravo • 704-902 Rev. F • 10/08
should be taken so that the ports are not covered. Place
the dime-size ember pieces near the ports, but not on the
ports (see Figure 12.1). Failure to follow this procedure
will likely cause lighting and sooting problems.
Place material near ports but do NOT cover
port openings.
EMBER
M ATERIA L
Figure 12.1 Placement of Embers
ance servicing. The embers provided should be enough
for 3 to 5 applications.
®
onto the burner care
Advertisement
Table of Contents
