Meridian system straight out of the box. You can simply by entering the appropriate device code on the numeric also program it to control your other equipment.
Installing the batteries I n t r o d u c t i o n The MSR+ is supplied with four AA batteries, and these need to be • Insert the four AA batteries accordingly: installed before you can use it. Note: Dispose of used batteries thoughtfully.
Using the MSR+ U s i n g Using the MSR+ to control your Meridian equipment The following diagram gives a summary of the MSR+ commands used for controlling Meridian products: Menu keys Indicator For navigating Flashes when you Transport keys...
The nine source keys: AUX, DISC, TAPE, TV, CABLE, SAT, VCR1, VCR2, and GAME can be programmed to control other equipment Your Meridian controller will select that source. In addition, the in your system as described in Programming your MSR+ , page 5.
Page 7
P r o g r a m m i n g Introduction Dedicated (punch through) Meridian keys Some keys on the MSR+ are dedicated to controlling your Meridian For convenience the MSR+ provides three alternative programming system and cannot be reprogrammed for your other products: options to allow you to control ‘other products’;...
A complete list of device codes for each of the supported products is given at To reset the source key to control Meridian products enter the the back of this manual.
Page 9
P r o g r a m m i n g • Enter one of the following codes using the numeric keypad to • To step back through the device library if you overshoot press indicate the type of product you want to control. Mute on the MSR+.
Page 10
Note: You cannot program the dedicated Meridian keys; see 5-8cm Dedicated (punch through) Meridian keys , page 5. Also, you cannot (2-3") learn commands if the battery level is low. In these cases the indicator will flash six times when you try to enter the learning...
Page 11
P r o g r a m m i n g • Press and release the key on the MSR+ that you want to use for Alternatively if you leave the MSR+ without pressing a key for a particular command. more than 20 seconds the LED indicator will flash six times and the MSR+ exits from learning mode, remembering any keys you have The indicator will light up to show that the MSR+ is waiting to...
Page 12
• Enter the code 9990 on the numeric keypad. The indicator will turn off, and all sources are reset to their default Meridian codes. Note: You can reset an individual source by specifying device code 8888; see Specifying a device code , page 6...
Page 13
The MSR+ is supplied with 12 standard source keycaps, The top row of keycaps (except OFF) can then be removed. corresponding to the 12 standard sources on the Meridian preamplifiers and controllers. Some additional keycaps are supplied with the MSR+ and you can substitute these for the standard keycaps to suit the particular combination of products in your system.
The volume A and V, Mute, and OFF keys are dedicated to remote control signals not supported by the MSR+. controlling the Meridian system even when the source key is programmed for another manufacturer’s product. To control the The indicator light does not light up when I press key television volume or power hold down Function when using the Try removing and refitting the batteries.