Snapper 580.752660 Operator's Manual page 6

KNOW YOURPRESSURE W ASHER
Read the Operator'sManual and safety rules before operatingyour pressure washer.
Comparethe illustrations with your pressure washer to familiarize yourself with the locations of various controls and
adjustments. Savethis manual for future reference.
A - Spray Gun-- Controls the application of water onto
cleaning surface with trigger device. Includes trigger lock.
B - High PressureHose -- Connect one end to water pump
and the other end to spray gun.
C - Cleaning Tank - Use to hold up to two gallons (7.6 I) of
pressure washer safe detergent.
D - ChokeLever -- Prepares a cold engine for starting.
E - Air Filter -- Protects engine by filtering dust and debris
out of intake air.
F - Recoil Starter -- Used for starting the engine manually.
G - StandardDetergent SiphoningTube/Filter -- Use to
siphon pressure washer safe detergents into the low
pressure stream.
H - PrecisionSpray
TM
Selector -- Containssix different
setting for various applications.
J - Throttle Lever -- Sets engine in starting mode for recoil
starter and stops a running engine.
K - Water Inlet -- Connectionfor garden hose.
L - Oil Drain -- Drain engine oil here.
M - High PressureOutlet-- Connectionfor high pressure
hose.
H - AutomaticCool DownSystem-- Cycleswater through
pump when water reaches 125°-155°F. Warm water will
discharge from pump onto ground. This system prevents
internal pump damage.
P - Pump -- Develops high pressure.
R - Fuel Tank -- Fill tank with regular unleaded fuel. Always
leave room for fuel expansion.
Items Not Shown:
IdentificationLabel (near rear of base plate) -- Provides
model and serial number of pressure washer. Pleasehave
these readily available if calling for assistance.
Oil Fill -- Check and add engine oil here.
Warning/OperatingInstructionsTag -- Identifies hazards
and proper procedure to start/stop pressure washer.