Advertisement
Available languages
Available languages
How to Stop Your Pressure Washer
1.
Releasespray gun trigger and let engine idle for two
minutes.
2.
Move throttle to SLOW position, then STOPposition.
A. WARNING: Backfire, fire or engine damage could
occur.
• DO NOT stop engine by moving choke control to "Choke"
position (J"J).
3.
ALWAYS point spray gun in a safe direction, press red
button and squeezespray gun trigger to releaseretained
high water pressure.
IMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
A. WARNING:The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
How to Use PrecisionSpray
TM
Selector
Refer to the PrecisionSpray
TM
Selector instruction sheet for
proper use.
NOTICE:Product damage will occur if the gun trigger is
squeezedwhile the Selector is in-between nozzle settings.
• NEVER turn theSelector whilespraying.
Cleaning and Applying Detergent
A. CAUTION: Chemicals can cause bodily injury, and/or
property damage.
• NEVERuse caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Toapplydetergentfollowthesesteps:
1.
Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
NOTICE: Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
2.
Prepare detergent solution as required by job.
3.
Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
4.
If using cleaning tank, pour detergent into cleaning tank.
NOTE:The cleaning tank holds two gallons.
NOTICE:Cleaningtank damage may occur if not drained
prior to removing handle.
5.
Rotate PrecisionSpray
TM
Selector to a low pressure
position, as described in the PrecisionSpray
TM
Selector
instuction sheet.
NOTE:Detergent cannot be applied with the PrecisionSpray
TM
Selector in a high pressure position.
6.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE:You must attach all hoses before you start the
engine.
• Startingthe enginewithoutall the hosesconnected andwithout
thewaterturnedONwill damage the pump.
• Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
7.
Start engine following instructions How to Start Your
Pressure Washer.
13
Advertisement
