Section 7: Trouble Shooting Guide - Ryobi 454 Operator's Manual

SECTION 7: TROUBLE SHOOTING GUIDE
Possible Cause(s)
Fuel tank empty, or stale fuel.
Trouble
Engine fails to
start
Engine runs
erratic
Engine over-
heats
Tines do not
engage
Tines skip over
ground
Wheels do not
engage
Throttle control lever not in correct
starting position (if so equipped).
Blocked fuel line.
Dirty aircleaner.
Choke not in ON position.
Spark plug wire disconnected.
Faulty spark plug.
Engine flooded.
Unit running on CHOKE.
Spark plug wire loose.
Blocked fuel line or stale fuel.
Vent in gas cap plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.
Engine oil level tow.
Dirty air cleaner.
Air flow restricted.
Carburetor not adjusted properly.
Foreign object lodged in tines.
Tine clevis pin(s) missing.
Pulley and idler not in correct
adjustment.
Not shifting properly.
Control cable not adjusted properly.
Belt worn and/or stretched.
Improper rotation.
Clevis pin missing.
Tiller is not being shifted properly.
Control cable not adjusted properly.
Belt worn and/or stretched.
Corrective Action
Fill tank with clean, fresh gasoline. Fuel wilt not last over
thirty days unless a fuel stabilizer is used.
Move throttle lever to start position.
Clean fuel line.
Refer to the engine manual packed with your unit.
Move switch to ON position.
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to the engine manual packed with your unit.
Move choke lever to OFF position.
Connect and tighten spark plug wire.
Clean fuel line; fill tank with clean, fresh gasoline. Fuel will
not last over thirty days unless a fuel stabilizer is used.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Fill crankcase with proper oil.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Adjust carburetor as instructed in separate engine manual.
Dislodge foreign object.
Replace tine clevis pin(s).
Take unit to authorized service dealer.
Refer to Controls section of operator's manual for proper
shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.
Forward rotation should only be used on soil that has
already been tilled, not on virgin soil.
Replace clevis pin.
Refer to Controls section of operator's manual for proper
shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.
NOTE:
For repairs beyond the minor adjustments above, contact your local authorized service dealer.
12