Ryobi 410r Operator's Manual

Ryobi 410r Operator's Manual

2-cycle garden cultivator
Hide thumbs Also See for 410r:

Advertisement

410r
2-Cycle Garden Cultivator
OPERATOR'S MANUAL
FOR QUESTIONS, CALL 1-800-345-8746 in U.S. or
1-800-265-6778 in CANADA
www.ryobi.com
IMPORTANT MANUAL
DO NOT THROW AWAY

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi 410r

  • Page 1 410r 2-Cycle Garden Cultivator OPERATOR’S MANUAL FOR QUESTIONS, CALL 1-800-345-8746 in U.S. or 1-800-265-6778 in CANADA www.ryobi.com IMPORTANT MANUAL DO NOT THROW AWAY...
  • Page 2: Table Of Contents

    Dial: • 1-800-345-8746 or www.ryobi.com on the world wide web for authorized service dealers in the United States • 1-800-265-6778 in Canada to obtain the listing of the authorized service dealer nearest you.
  • Page 3: California Emission Regulations

    CALIFORNIA EMISSION REGULATIONS This unit meets the 1995 to 1999 California emissions regulations for small off-road engines. These units are identified by the label on the engine of your product. A typical identification label is shown. To ensure that your unit continues to meet these regulations, refer to the following information and instructions in this operator’s manual.
  • Page 4: Rules For Safe Operation

    The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures.
  • Page 5: Safety And International Symbols

    • The tines become very sharp from use. Always wear heavy gloves when handling, removing, installing or cleaning the tines. • Use only genuine Ryobi replacement parts and acces- sories for this unit. These are available from your authorized service dealer. Use of any non Ryobi parts or accessories could lead to serious injury to the user, or damage to the unit, and void your warranty.
  • Page 6 RULES FOR SAFE OPERATION SYMBOL MEANING • WEAR EYE AND HEARING PROTECTION WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. Wear eye protection meeting ANSI Z87.1 standards and ear protection when operating this unit. •...
  • Page 7: Know Your Unit

    RULES FOR SAFE OPERATION KNOW YOUR UNIT APPLICATION Use this unit for cultivating sod and light to medium soil. Also for cultivating in garden areas, around trees, etc. Handgrip START/ON (I) On/Off Stop Control Fuel Cap Throttle Control Handgrip Throttle Cable STOP/OFF (O) Starter Rope Grip...
  • Page 8: Assembly Instructions

    ASSEMBLING THE UNIT Your yard and garden cultivator has been completely assembled except for the handlebar, throttle cable and wheel bracket assembly. A large phillips screwdriver is needed for assembly. Unpacking 1. Carefully unpack the contents and insure that nothing is damaged. Unwrap the throttle cable without bending or kinking it.
  • Page 9: Installing The Handlebar

    INSTALLING THE HANDLEBAR 1. Place the handlebar between the bottom and middle clamp pieces (Fig. 4). 2. While holding the three pieces together, position the handlebar underneath the shaft tube and align with the top clamp. NOTE: The holes in the clamp assembly will line up only when assembled correctly.
  • Page 10: Throttle Cable Assembly

    THROTTLE CABLE ASSEMBLY 1. Wrap the throttle wire once around the handlebar (Fig. 8). 2. Depress the throttle trigger and locate hole for the throttle wire (Fig. 9). 3. With the throttle trigger depressed, place the barrel end of the throttle wire inside the hole of the trigger (Fig.
  • Page 11: Oil And Fuel Information

    FILLING THE FUEL TANK Fill or add fuel to the tank only when the cultivator is in a horizontal position (Fig. 13). with one 4 oz. (120 ml.) bottle of RYOBI 2 CYCLE OIL makes a 32:1 fuel/oil ratio. RYOBI 2 CYCLE OIL 1 US.
  • Page 12: Starting/Stopping Instructions

    STARTING/STOPPING INSTRUCTIONS STARTING INSTRUCTIONS WARNING: Avoid accidental starting. Be in the starting position when pulling the starter rope (Fig. 16). The operator and unit must be in a stable position while starting to avoid serious personal injury. WARNING: Operate this unit only in a well ventilated area outdoors.
  • Page 13: Operating Instructions

    Do not wear short pants, sandals or go barefoot. 1. Move the cultivator to the work area prior to starting the engine. The cultivator may be transported by pushing it on wheels or carrying it by the shaft tube grip.
  • Page 14: Maintenance And Repair Instructions

    “R” stamped on the tines will appear on the right side of the cultivator and the letter “L” will appear on the left side from the normal operating position. It is important that the tines are installed correctly.
  • Page 15 MAINTENANCE AND REPAIR INSTRUCTIONS Choke Control Screws Fig. 21 Cleaning the Air Filter WARNING: To avoid serious personal injury, always turn the unit off and allow it to cool before you clean or perform any maintenance on it. Clean and re-oil the air filter every 10 hours of operation. It is an important item to maintain.
  • Page 16: Carburetor Setting

    MAINTENANCE AND REPAIR INSTRUCTIONS CARBURETOR SETTING The idle speed adjuster of the engine is adjustable through the Air filter/muffler cover (Fig 26). NOTE: Careless adjustments can seriously damage your unit. An authorized service dealer should make carburetor adjustments. Check Fuel Mixture Old and/or improperly mixed fuel is usually the reason for the unit not running properly.
  • Page 17: Cleaning And Storage

    CLEANING THE UNIT WARNING: To avoid serious personal injury, always turn the unit off and allow it to cool before you clean or perform any maintenance on it. • Use a small brush to clean off the outside of the unit and to keep the air vents free of obstructions.
  • Page 18: Troubleshooting Chart

    ENGINE LACKS POWER OR STALLS WHEN UNDER LOAD C A U S E Old or improperly mixed fuel Improper carburetor adjustment Cultivator tines bound with dirt or grass TROUBLESHOOTING A C T I O N Turn the On/Off Stop Control to START...
  • Page 19: Specifications

    Fuel Tank ............... HD Polyethylene DRIVE SHAFT AND CULTIVATOR Drive Shaft Tube .
  • Page 20 NOTES...
  • Page 21 • In order to file a claim, go to your nearest Authorized Ryobi Service Center. Warranty services or repairs will be provided at all Authorized Ryobi Service Centers. • Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner.
  • Page 22: Warranty

    RYOBI Operator’s Manual. This warranty does not apply to any damage to the RYOBI Product that is the result of improper maintenance or to any RYOBI Product that has been altered or modified so as to...

Table of Contents