Table of Contents
Advertisement
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes,
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
Utility knife
Pliers
(1) 3/4" wrenches
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR
FROM CAR-
TON
UNPACK CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR
FROM
SKID
ATTACH STEERING
WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
•
Slide extension shaft onto lower steering shaft. Align
mounting holesin extension and lower shafts and install
1/4 hex bolt and Iocknut. Tighten securely.
IMPORTANT:TIGHTEN BOLTAND NUT SECURELYTO 10-12
FT. LBS TORQUE.
•
Place tabs of steering boot over tab slots in dash and
push down to secure,
INSTALL STEERING WHEEL
•
Position front wheels of the tractor so they are pointing
straight forward.
•
Remove steering wheel adapter from steering wheet
and slide adapter onto steering shaft extension.
•
Position steering wheel so cross bars are horizontal
(left to right) and slide inside boot and onto adapter,
•
Assemble large flat washer, 1/2 hex nut and tighten
securely.
Snap steering wheel insert into center of steering
wheel.
•
Remove protective materials from tractor hood and
grill,
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
EXTENSION
SHAFT
j
114 HEX BOLT
FIG. 1
HOW TO SET UP YOUR TRACTOR
INSTALL
SEAT
(See Fig. 2)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
•
Pivot seat upward and remove fi'omthe cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable
position is reached
which allows you to press clutch/brake pedal all the
way down.
6
Advertisement
Table of Contents
