Provide barriers or shields as needed. ELECTRICAL SAFETY Grounded tools must be plugged into an outlet properly installed and grounded in accordance with all codes and ordinances. Never remove the grounding For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 2...
Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the power tool in unexpected situations. For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 3...
Page 4
When servicing a tool, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 4...
Industrial applications must follow OSHA requirements. Maintain labels and nameplates on the Saw. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement. Always wear ANSI approved safety impact eye goggles and heavy work gloves when using the Saw.
Page 6
Do not exert side-to-side pressure on the Saw Blade (59, 60) or attempt to cut curves. Doing so will break the Saw Blade and possibly cause pieces of the blade to fly outward, causing injury. For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 6...
Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.) FIGURE A For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 7...
If you are using one extension cord for more than one tool, add the nameplate am- peres and use the sum to determine the required minimum cord size. (See Figure For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 8...
Page 9
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes. SYMBOLOGY Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current Amperes No Load Revolutions xxxx/min. per Minute (RPM) For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 9...
Page 10
UNPACKING When unpacking, check to make sure that the tool is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
With the Reciprocating Saw “ON”, place the Saw Blade (59, 60) against the material to be cut. Press down slightly on the Reciprocating Saw to help it cut. (See Figure B.) For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 11...
NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 12...
Only available as part of Stator/Lift Body Assy. (64) Screw Nut NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. REV 10/05 For technical questions, please call 1-800-444-3353. SKU 4095 PAGE 13...
LIMITED 90 DAY WARRANTY Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.