Setting Up The System; Setup After Connection - Pioneer PDP-505HD Operating Instructions Manual

Setu£ after connection
After components have been connected to INPUT3 or
INPUT4, on-screen setup is necessary
Follow the procedure described below and make settings
as they apply to the type of components connected,
(Procedures are written in reference to the remote control
unit unless the button or control is only present on the
main unit)
mY,
--
--2
--5,6,7
8,9 4,10--
--3
--5,6,7
8,9
1
Switch MAIN POWER on the main unit to the on
position to turn the main power on.
The STANDBY/ON indicato_ lights _ed
2 Press (_) STANDBY/ON to put the unit in the
operation mode.
The STANDBY/ON indicato_ turns g_een
3 Select INPUT3 or INPUT4.
4
Press MENU to display the menu screen.
The menu screen appears
5 Press A/V to select SET UP, then press
SET/SELECT.
6
Press A/V to select SIGNAL, then press
SET/SELECT.
7
Press </_ to select the input signal.
When a personal computer is connected, set to "PC",
When a component other than a personal computer is
connected, set to "VIDEO"
After selecting, press SET/SELECT to enter your
selection
Note
Steps 6 to 7 are necessary when inputting a signal of horizontal
frequency 31 5kHz/vertical frequency 60Hz For signals of other
frequencies, settings are done automatically, and therefore
cannot be performed