Playback; Single Playback; Blank Skip; Relay Playback - Pioneer CT-W770 Operating Instructions Manual

PLAYBACK
SINGLE PLAYBACK
(Either DECK I or DECK II)
1 5 (5) (1)
1. Load a prerecorded tape in DECK I or II.
2. Set the DOLBY NR switch.
• Always set the switch to the same position that was used
for recording.
3. Set the REV MODE switch to ----- or --_ (see page 8).
4. Set the stereo amplifier for tape playback.
5. Press the playback (• or <) button of either DECK I or
II.
To stop playback temporarily (DECK II only)
Press the pause ( II ) button.
• To resume playback, either press the pause ( II ) button again,
or press the playback (1_ or _1)button.
To stop playback
Pressthe stop {11)button.
REV MODE
I RELAY PLAYBACK
I BLANK SKIP
1
This function allows you to skip unrecorded portions of the tape
during playback.
Set the REV MODE switch too.
NO TE:
• When the REVMODE switch is set to _ positfz_ relay mode
will be selected.
5 (5) (1)
1
When relay playback mode is selected, continuous playback can
be performed. When the tape in the first deck reaches its end and
stops, the other deck will automatically begin playback.
1. Load prerecorded tapes in DECK I and DECK II.
2. Set the DOLBY NR switch.
• Always set the switches to the same positions that were
used for recording.
3. Set the REV MODE switch to _-_ (see page 11).
4. Set the stereo amplifier for tape playback.
5. Press the playback (• or <) button of the deck that
will start _o play first.
• When the tape in one deck ends, the other deck automati-
cally begins playback.
• To cancel relay playback, press the stop (11) button.
NO TES:
• Relay playback can begin from either DECK I or DECK II.
• The tape in the idle deck can be replaced during relay playback
mode, allowing many tapes to be played back continuously.
This is a convenient feature for parties, background music, etc.
• When this mode is selected, ff the deck encounters an unre-
corded portion of tape more than 15 seconds in length, it will
fast forward the tape until it encounters another recorded por-
tion, and resume playback from that poinL
To stop playback temporarily (DECK II only)
Press the pause ( II ) button.
• To resume playback, either press the pause ( II ) button again,
or press the playback (1_ or <1)button.
To stop playback
Press the stop (11) button of the operating deck.
10
<RRB1150>
En