Advertisement
MAINTENANCE
AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console,
keep liquids
away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
if the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 22.
if the console does not display your heart rate
when you use the heart rate monitor, see
TROUBLESHOOTING
on page 16.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, press and
hold the QuadsfTibialis/Core
button for several sec-
onds until the test mode appears in the display.
Press the Quads/Tibialis/Core
button again. Then,
press the Incline/Decline
increase or decrease button
to calibrate the ramp. The ramp will move upward and
downward as it calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the Quads/Tibialis/Core
button repeatedly
to exit the calibration mode.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual, if the Rollers (51) squeak when moving on
the Tracks (11), apply a small amount of white marine
grease equally to each Roller. Spread the grease
evenly around the Rollers. Pedal the elliptical until a
thin film of grease is distributed along the Tracks; then,
wipe off any excess grease.
HOW TO ADJUST THE DRIVE BELT
if the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt,
first use a flat screw-
driver to remove the
Lower Upright Cover
(56).
56
Next, remove the M4
x 16mm Screw (104),
and then use a flat
screwdriver to remove
the Shield Cover (75).
Then, use a flat screw-
driver to remove the
Front Stabilizer Cover
(8).
.....
Remove all the M4 x 16mm Screws (104) from the
right Disc (71). Then, gently remove the right Disc.
27
Advertisement
