Table of Contents
Advertisement
MODELS
WITH
SPARK
PLUG TO REAR
OF MOWER
To prevent
cable damage,
the cable must
be attached
to the side of engine,
away
from the muffler.
• Above
the muffler,
locate the hole in en-
gine shroud.
Install supplied
cable clip
on cable and assemble
to side of engine
with supplied
hex head screw.
Tighten
securely.
MODELS
WITH TECUMSEH
ENGINE
• Straighten
cable and find the end with
the small tapered
plastic
fitting.
• Hook the "Z" bend fitting on inner wire of
cable into hole as shown.
• Align the tapered
end of the plastic
fitting
with the hole in the mounting
bracket
and push in until fitting snaps
into place.
• Route cable
under crossbar
portion
of
lower handle
and up to upper
handle
control
bar.
• Hook "Z" bend fitting on inner wire into
hole in control
bar (See "ASSEMBLE
CABLES
TO UPPER
HANDLE"
in this
manual).
TECUMSEH
ENGINES
WITH SPARK PLUG FORWARD
Mounting
bracket
Small
fitting X
TECUMSEH
ENGINES
WITH
SPARK
PLUG
REARWARD
Z" Fitting
MODELS
WITH
BRIGGS
& STRATTON
QUANTUM
ENGINES
• Hook the "Z" bend fitting on inner wire
of cable
(end with tapered
plastic
fitting)
into hole in brake lever of engine.
Cor-
rect brake lever to use is determined
by
position
of spark plug on your mower
- forward
or rearward.
• Position
the tapered
plastic
fitting
into
the mounting
bracket
on engine.
Snap
fitting
into place.
• Route cable
under crossbar
portion
of
lower handle
and up to upper handle
control
bar.
• Hook "Z" bend fitting on inner wire into
hole in control
bar (See "ASSEMBLE
CABLES
TO UPPER
HANDLE").
Brake lever (rearward spark plug)
Brake lever
(forward spark
plug)
Mounting bracket
(rearward spark plug)
Mounting bracket
(forward spark plug)
ASSEMBLE
CABLE(S)
TO UPPER
HANDLE
(USE
HARDWARE
GROUP
"F")
• Assemble
cable(s)
to opposite side of
upstop
bracket.
• Be sure to route cable(s)
underneath
crossbar
of lower handle.
• Position
throttle
control
(if equipped)
on outside
of handle
and zone control
square
fitting
on the inside.
• Secure
to handle
with the 1/4-20
ma-
chine
screw or hex bolt supplied
and
Iocknut
as shown.
Tighten
securely.
• Secure
cable(s)
to crossbar
and lower
handle
with cable ties as needed.
"Z" Fittinc
Mountinc
bracket
plastic
fitting
14
Hide quick links:
Advertisement
Table of Contents
