Murray 201012X83E Operator's Manual page 13

BRIGGS& STRATTONENGINESHOWN
(Clamp and Screware preassembledon
Tecumsehengines)
Speed lever
# 10 x 5/8
Hex head screw
BRIGGS & STRATTON CLASSIC AND
SPRINT ENGINES WITH THE SPARK
PLUG TO FRONT OF MOWER
• Attach throttle cable to side of engine
housing with cable clip and #10 x 5/8 hex
washer head screw. Tighten securely.
cable
#10 x 5/8
Hex head screw
Cable clip
MODELS WITH BRIGGS & STRATTON
QUANTUM ENGINES
• Slide throttle lever on engine to CHOKE
position (away from spark plug). Push
gently beyond first stop to lock in detent
(CHOKE position).
• Insert wire "Z" bend of throttle cable into
throttle lever hole from top side.
• Secure throttle cable to engine with
QUANTUM ENGINES -
SPARK PLUG TO REAR OF MOWER
Throttle
Diecast
clam
Hex Head Screw #10 x 5/8
cable
ASSEMBLE ENGINE ZONE
CONTROL CABLE TO ENGINE
(NO HARDWARE REQUIRED)
Follow the appropriate instructions below
for the brand or type of engine on your
lawn mower.
MODELS WITH BRIGGS & STRATTON
CLASSIC OR SPRINT ENGINE
Cable attaches under the brake arm cover,
which is opposite the spark plug end of
engine.
• Straighten cable and find the end with
the small plastic fitting.
• Hook the "Z" bend fitting on inner wire of
cable into hole in brake arm of engine.
• Align the tapered end of the plastic fitting
with the hole in mounting bracket and
push in until fitting snaps into place.
• Route cable below crossbar portion of
lower handle and up to upper handle
control bar.
• Hook "Z" bend fitting on inner wire into
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE" in this
manual).
Engine cable clip Brake Mounting
(rearward spark plug arm bracket
diecast clamp and #10 x 5/8 hex head models only) cover / Brake
screw and tighten securely.
.,,.._,j_.,_ ,arm
QUANTUM ENGINES- _r_
SPARK PLUG TO FRONT OF MOWER
/ Throttle cable .. __
Hex _
_/.7..
ead
Screw _ ___ 7 "Z" Fitting
• "Throttle
_--_,__ ,, Ieve r
Diecast clamp
Small plastic fitting
Hex head screw #10 x 5/8
(rearward spark plug models only)
13