Advertisement
Available languages
Available languages
STARTING
INSTRUCTIONS
WARNING: Avoid accidental
starting. Make sure
the operator
and unit must be in a staMe
)osition while starting.
You must follow this sequence correctHy to start the unit.
1. Make sure you have pHugged in the unit.
2.
Press in and hoHdthe red starter button (Fig. 4).
3. WhiHe hoHding the starter button, lift and hoHdthe bail
NOTE: The unit will NOT start if you faiHto press and
hoHdthe starter button untiHyou Hiltthe bail
4.
HoHdthe baiHand begin operating the unit (Fig. 5).
STOPPmNG mNSTRUOTmONS
1. ReHeaseyour hand from the bail.
2. The starter button will pop out and the unit will stop.
Overload
Protection
Switch
F_g. 4
OVERLOAD
PROTECTION
SWITCH
This unit is equipped with an ovedoad protection switch
to protect the circuit (that the unit is plugged into) from
short circuit overloads.
If the switch pops out:
1.
Release the bail and allow the unit to stop and cool
for a minute.
2.
Press the overload switch to reset. Resume
operation (Fig. 4).
If the switch pops again shortly after the first time:
1. Allow the unit to cool for 15 to 30 minutes.
2. After the unit has cooled, press the ovedoad switch
to reset. Resume operation.
If the switch does not stay in, or if it continues to pop out
during operation, take the unit to an authorized service
dealer for repair.
OPERATING
THE UNiT
1. Start the unit according to the Starting Instructions.
The depth and weight of the snow governs the
forward speed.
2.
Push the unit so that it rides on the wheels and
scraper.
3.
Make sure the power cord is attached to the cord
retainer and rests on the guide bar. The power cord
should trail to the side of the operator.
Advertisement
