Tools Required For Assembly - Murray 20112X92E1 Instruction Book

Parts packed separately in carton
\\ \\ (1)
\\ \\ Control
_ _o Bar
(1) Upper Handle (1) Lower Handle i
( ) ( ) ' g rd Cable
Parts Bag
Contents
(not shown
full size)
(1) Rope Guide
(1) Upstop Bracket
_:_CAUTION: Do not operate this mower
without the discharge guard or an entire
approved grass catcher in place. These
guards are for your protection and are
required by the American National Stan-
dards Institute and Consumer Products
fety Commission.
AUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new lawn mower.
IMPORTANT: This lawn mower is
shipped WITHOUT OIL OR GASOLINE in
the engine.
Your new lawn mower has been assem-
bled at the factory with the exception of
those parts left unassembled for shipping
purposes. All parts such as nuts, washers,
bolts, etc., necessary to complete the as-
sembly have been placed in the parts bag.
To ensure safe and proper operation of
your lawn mower, all parts and hardware
you assemble must be tightened securely.
Use the correct tools as necessary to
ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 5/16" Wrench (1) Adjustable Wrench
(1) 7/16" Wrench (1) 9/16" Wrench
(1) 1/2" Wrench (1) 3/4" Wrench
When right hand or left hand is mentioned
in this manual, it means when you are
standing in the operating position, behind
the handle.
UNPACK CARTON
1. Remove all loose parts from carton.
2. Examine all items. Compare with list of
unassembled parts and hardware.
3. Remove lawn mower housing with
care. Avoid touching blade under
housing. Always wear gloves or other
protection when working under or lifting
mower.
ASSEMBLE LOWER HANDLE
NOTE: For ease of lower handle as-
sembly, raise rear of mower housing and
6 block securely.