Craftsman WEEDWACKER Incredi-Pull 316.791191 Operator's Manual page 4

CRAFTSMAN 2 YEAR FULL WARRANTY
FOR 2 YEARS from the date of purchase, this product is warranted against any defects in material or workmanship. Defective product will receive free repair or
free replacement if repair is unavailable.
For warranty coverage details to obtain repair or replacement, visit the web site: www.craftsman.com
This warranty covers ONLY defects in material and workmanship. Warranty coverage does NOT include:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
Product damage resulting from user attempts at product modification or repair or caused by product accessories.
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty is void if this product is ever used while providing commercial services or if rented to another person.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Sears Brands Management Corporation, Hoffman Estates, IL 60179
APPLICATIONS Mumer
As a trimmer: \
\
• Cutting grass and light weeds
Edging
Decorative trimming around trees, fences, etc. Shaft Grip
Other optional accessories may be used with this unit.
Spark Plug
Starter Rope
Grip
D-Handle
On/Oft
Control
\
Air Filter
Cover
Fuel Cap
Shaft Housing
Throttle
Control
Primer Bulb
Convertible
TM
Coupler
Line Cutting Blade
Cutting Head Shield
Cutting
INSTALL CUTTING HEAD SHIELD
--
i
_L_ ARNING:
To prevent serious personal injury, never operate
the trimmer without the cutting head shield in place.
Use the following instructions if the cutting head shield on the unit is not
installed.
1. Place the cutting head shield
onto the guard mount
bracket, making sure to align
the holes on the shield with
the ones in the guard mount
bracket. (Fig. 1)
2. Take the 2 shield screws and
screw each one into the
shield until finger tight.
3. Using an appropriate screw
driver, tighten the screws until
the shield is firmly in place.
• Screw (2)
Cutting _ _ Guard
HeadShie,d \ \ BrackeMeUntt
Fig. I
INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down onto Shaft Grip Shaft Housing
the shaft housing (Fig. 2). The ___._
hex bolt hole in the handle D-Handle
should be on the left side.
2. Insert the bolt into the hex
hole in the handle and push _ "kJ__'_._ Tighten
through. Place the washer on Minimum 6 in. _-"_-'_r-_ Wing
the bolt, then screw the wing
nut onto the bolt. Do not (15.24 cm) J_-"_l_ Nut
tighten until making the
handle adjustment. Bolt -_ Washer
3. Rotate the D-handle to place Fig. 2
the grip above the top of the
shaft housing. Place it a minimum of 6 inches (15.24 cm) from the end
of the shaft grip.
4. While holding the unit in the operating position (Fig. 10), move the D-handle
to the location that provides the best grip.
5. Tighten the wing nut until the D-handle is secure.