Advertisement
l
your
TV remote
can be set to
ork various
accessory
devices
such as VCRs, Cable
Boxes, Satellite
Receivers,
DBS,
DVD, etc. by using the search
method.
lf the Direct Access
method
shown on page 37 did not set
your remote to work your acces-
sory device, follow
the easy steps
listed below.
Please read steps 1-4 before
beginning.
Turn ON the device by press-
the POWER button on the
device you are attempting to pro-
gram.
@:_
Place the "IW/VCII/ACC
I Mode Switch in the proper posi-
tion.
<_
Preas and hold the VCR
RECORD and the SMART
SOUND buttons simultaneous-
ly.
The device will begin to
change channels after the remote
identifies the correct code. When
the channels start to change,
release the VCR RECORD and
SMART SOUND buttons. The
remote should be ready to oper-
ate the device.
O
This method can take up to
two minutes to perform.
Don't let the device change more
than five channels after the remote
identifies the code. If you do, the
remote may pass up the right code;
another two minute search cycle will
have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change stil not
occur, the remote will not work the
desired device.
Satellite Receiver,
DBS, DVD,
or similar device
Cable Converter
VCR
38
Advertisement
