Advertisement
Questions?
Use This Problem Solver
PROBLEM
POSSIBLE
CAISE
AND REMEDY
OVEN WILL NOT WORK
Plug on range is not completely inserted in the electrical outlet.
The circuit breaker
in your house has been tripped, or a fuse has been blown.
Oven controls not properly set.
Door left in locked position after cleaning.
OVEN LIGHT
Light bulb is loose.
DOES NOT WORK
Bulb is defective. Replace.
Switch operating oven light is broken. Call t_r service.
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT ROAST
OR BAKE PROPERLY
OVEN SET knob not set at BROIL.
OVEN TEMP knob not set at BROIL.
Door not left ajar as recolmnended.
hnproper
shelf position being used. Check Broiling Guide.
Necessal?: preheating
was not done.
Food is being cooked on hot pan.
Utensils are not suited for broiling.
Aluminum foil used on the broil pan rack has not been fitted properly and slit
as recommended.
OVEN SET knob not set on BAKE.
OVEN TEMP knob not set correctly.
Shelf position is incon'ect. Check Roasting or Baking Guides.
Oven shelf is not level.
h:correct cookware or cookware
of improper size is being used.
A foil tent was not used when needed to slow down browning during roasting.
CALROD ® SURFACE
UNITS
Surface units are not plugged in solidly.
NOT FUNCTIONING
Trim tings and drip pans are not set securely in the range top.
PROPERLY
Surface unit controls are not properly set.
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR
WON'T LATCH
Automatic timer dials not set or not set properly. Clock must be set to time of day
and the STOP dial must be set and advanced beyond the time noted on oven clock.
The STOP dial was not advanced for long enough.
Both OVEN SET and OVEN TEMP knobs nmst be set at CLEAN setting.
A thick pile of spillover when cleaned leaves a heavy layer of ash in spots
which could have insulated the area from further heat.
Latch not moved to the right.
Turn OVEN SET knob to CLEAN. Glowing Locked Light after knob is turned
indicates oven is too hot from previous use and door won't latch. To cool oven,
open door wide, then Latch can be moved.
OVEN SET knob must beat CLEAN or OFF before Latch can be moved.
If you need more
help.,
call, toll
GE Answer
Center"
800.626.2000
consumer
information
service
free:
26
Advertisement
