Planning the Wiring
All wire connections and installations must be in
compliance with local codes In the absence of loca!
electrical codes consult the National Electric Code
[]
[]
The (]o_ndraf_ blower system draws 4 AMPS
and requires a 120 VAt!, 60 Hz circuit,
Plan to provide a grom_ded outlet in a
location
_dfi(:h will all(m die mlit's
p(mer
cord _o reach.
[_]
()n 36'model,
)ian tile P_ISEt£OWER
s_d_(:h.
•
.
_Ott
Tile lead _o _he sx_(:h is /= long.
Theoutlet cannot be located on a back wall,
The outlet
needs to be momlted
on the side _all
of the (abinet
or it (ould
be on the ba(k _all of an
adjacent (abinet
_dth access dlrough
an o _ening
in the sk]e wall. (Based on h)(:al (:odes,)
Preparing
to Install the Downdraft
System
Changing Blower Discharge
The bl()v, er can b e m (mn ted in tlle ca bi net (,7 u nd er
die floor. The blower will fit between
fl()or ioisls on
-t
_6 (:ente_ s.
Discharge left
(shown with rectangular duct)
The vent is shipped wfih the outlet on the leR,
If die position of die dischmge needs _o be moved
so the ductwork does not inteHere with floor joists,
plumbing
or wMng below, make die following
changes:
To change die dischmge ii()m left _o righh remove
the screws holding die outle_ panel _o die bottom ()i
the venL Remove and rotate the panel and fi_sten
wi_h the screws.
Preparing the Blower
A transition
is provided
to (onne( t a 3E" x 10" (h]ct
_o die blowe_. A_ach
_he (]ud mmsi_ion
_o _he _op
of die blower wi_h the screws provided.
The blower
has holes dlat ma_(h
die _ransifion.
Donot driftadditional holes in the blower
If r(nmd ducfing is used, mmsidon to 6' _Druid to
connect _o _he inle_ of the blower.
/
Through the floor
phown withrectangularduct)
For installations
where the blower is mourned
in die cabineL a_tach _he moml_ing
suppo_ _sto file
corners of die blower housing on die motor side of
_he motor housing
K Ihe blo_x er is installed
raider
Ihe floor, at_a(:h tlle
suppor_ legs to the corners
of die blower housing
on
Ihe side dla_ tlle inlet duct a_taches.
The support legs are a(]iusmble for heigh_ by sliding
die _wo halves and tightening die bobs xdlen
ex_ended to tlle desired lengdl.
Discharge right
(shown wiffl (V'round duct)
_ /