GE Spacemaker PVM2070 Owner's Manual page 40

re and (;leaning
Co&top Light/
Night Light
Replace the burned-out bulb with a 120 volt,
20-watt halogen bulb (WB36X10213), available
from your GE supplier.
1 To replace the bulb(s), first disconnect the
power at the main fltse or circuit breaker
panel or pull the plug.
2 Remove the screw at the right edge of the
light covet" and push on the left edge of
the covet" to open,
3 Be sure the bulb(s) to be replaced are
cool betm'e removing. After breaking the
adhesive seal, remove the bulb by pulling
straight out. Replace with the same size
and type bulb.
4 Raise the light shield and replace the screw,
Connect electrical power to the oven,
RefRove screw
Oven Light
Replace the burned-out bulb with a 120 volt,
20-watt halogen bulb (WB36X10213), available
from your GE supplier.
1 To replace the oven light, first disconnect
the power at the main hlse or circuit breaker
panel or pull the plug.
2 Remove the top grille by taking out the
screws on top of the grille that hold it in
place and sliding the grille to the left
(opening the door makes grille remox_d
easier).
3 Lift off the light cover at the left of the top
opening.
4 Pinch the clips that hold the light socket in
place and lift the socket otlt.
5 Remove the bulb fl'om the light socket by
pulling straight out. Replace with the same
size and type bulb, then replace the light
socket and cover.
6 Replace the grille and scre*_s. Connect
electrical power to the o'_en.
Remove grille screws to renlove the grille
!-.
J 000
LightCover
40