GE Appliances PGB900 Owner's Manual And Installation Instructions page 51

Installation Instructions
ELECTRICAL CONNECTIONS
Electrical Requirements
120-volt, 60 Hertz, properly grounded dedicated circuit
protected by a !5-amp or 20-amp circuit breaker or time
delay fuse.
Note: Use of automatic, wireless, or wired external
switches that shut off power to the appliance are not
recommended for this product.
Grounding
[ WARN JNG j ShockHazard: T his
appliance must be properly grounded. Failure
to do so can result in electric shock.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
The customer should have the wall receptacle and circuit
checked by a qualified electrician to make sure the
receptacle is properly grounded.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with a
properly grounded three-prong wall receptacle.
DO NOT, UNDER ANY CIRCUMSTANCES,CUT OR REMOVE
THE THIRD (GROUND) PRONG FROMTHE POWER CORD,
DO NOT USEAN ADAPTER. DO NOT USEAN EXTENSION
CORD.
A word about GFCI's - GFCI's are not required or
recommended for gas range receptacles.
Ground Fault Circuit Interrupters (GFCI's)are devices that
sense leakage of current in a circuit and automatically
switch off power when a threshold leakage level is
detected. These devices must be manually reset by the
consumer. The National Electrical Code requires the use of
GFCI'sin kitchen receptacles installed to serve countertop
surfaces. Performance of the range will not be affected
if operated on a GFCI-protected circuit but occasional
nuisance tripping of the GFCIbreaker is possible.
SEAL THE OPENINGS
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
ASSEMBLE SURFACE BURNERS
Gq
Burner Heads (on some models)
Placeburner
heads over
the electrodes
on the
cooktop, in
the correct
locations
according to
their size.
IVlakesure the slot in the
burner head is positioned
over the electrode.
Front of range
Triple flame head
Hole
Electr_Slot
or
Front right burner
Ion some models)
[] Oval (Center) Burner Heed/Cop Assembly
Placethe oval (center) head/cap assembly over the
electrode on the cooktop.
Make sure the slot in the
Oval head and cap
assembly burner head is positioned
over the electrode.
, |o
Front of range Electrode
[_ Cops
Placethe matching size caps onto the burner bases
or heads.
Hake sure that the heads (on some models) and caps
are replaced in the correct locations.
_lodels)
front of range
Tn-nng cap
c_g
on sorne rnode s
51