GE Appliances PGB900 Owner's Manual And Installation Instructions page 32

Self-cleaning gas ranges
Hide thumbs Also See for Appliances PGB900:
Table of Contents

Advertisement

Available languages

Available languages

Care and cleaning of the range,
The oven door must be closed and all controls set correctly for the cycle to work properly.
i
SELF
I
I CLEANJ
DELAY
START
]
N N N
START
j
How to Delay
the Start
of Cleaning
Hake sure the clock shows the correct time of
day.
[Z] On models with Gas/Control Lockout,
[-_
touch and hold the Gas/Control Lockout
pad for 3 seconds to turn it off.
NOTE: The surface burners must be turned off
prior to the self-cleon start time.
Ifyour model has a latch, latch the door.
[]
@
Touch the Self Clean pad.
Using the number pads, enter the desired
clean time.
Touch the Delay Start pad. The earliest
start time you can set will appear in the
display.
[]
Using the number pads, enter the time of
day you want the clean cycle to start.
[]
Touch the Start pad.
On models without a door latch, the door locks
automatically. The display will show the start
time. It will not be possible to open the oven
door until the temperature drops below the
lock temperature and the LOCKEDDOOR light
goes off.
The oven shuts off automatically when the
clean cycle is complete.
When the LOCKEDDOOR light is off, slide
the latch handle to the left as far as it will
go and open the door. If your range does
not have a latch, the door will unlock
automatically.
The words LOCKDOORwill flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door or
forget to latch the door on models with a
latch.
To stop a clean cycle, touch the Clear/Off
pad. When the LOCKEDDOOR light goes
off, indicating the oven has cooled below the
locking temperature, unlatch the door (on
models with a latch) and open the door.
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
iiiiiiiiiiii_iii
iiiiiiiiiiii_iii
iiiiiiiiiiii_iii
You cannot set the oven for cooking until the
oven is cool enough for the door to unlock.
While the oven is self-cleaning, you can
touch the Clock pad to display the time
of day. To return to the clean countdown,
touch the Cooking Time pad.
If the shelves become hard to slide,apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
shelveswith the paper towel.
32

Advertisement

Table of Contents
loading

Table of Contents