Download Print this page

GE Monogram Owner's Manual page 11

Double-door, double-drawer, stainless steel, free-standing refrigerators
Hide thumbs Also See for Monogram:

Advertisement

Water Filter
Stainless
Steel Refrigerator
Water filter
The water filter cartridge is
located in the back upper
right corner of the
j f
refrigerator compartment.
When
to Replace
the Filter
There is a replacement indicator light for the
water filter cartridge on the temperature display.
This light will turn orange to tell you that you
need to replace the filter soon. The filter cartridge
should be replaced when the replacement
indicator light turns red or if the flow of water to
the dispenser or icemaker decreases.
On models with external dispensers, the top of
the LCDscreen will display, "Replace Water Filter."
Installing
the Filter
Cartridge
1 If you are replacing the
cartridge, first remove
the old one by slowly turning it
to the left. DO NOTpull down on
the cartridge. A small amount of
water may drip down.
5 Run 1V_ gallons from the dispenser to clear the
system and prevent sputtering.
See To Use the
Dispenser section.
6 Press and hold the RESETWATER
FILTERpad for 3 seconds.
NOTE:A newly-installed water
filter cartridge may cause water
to spurt from the dispenser.
FILTER
HOLD 3 SEC
Filter
Bypass
Plug
You must use the filter bypass plug when
a replacement filter cartridge is not available.
The icemaker will not operate without the filter
or filter bypass plug.
Replacement
Filters:
To order additional
filter
cartridges
in the United
States, visit our Website,
GEAppliances.com,
or call GE Parts and
Accessories,
800.626.2002.
Filter Model HWF
Customers
in Canada should consult the yellow
pages for the nearest Mabe Service Center.
A CAUTION: fair h as b een trapped
in
the system, the filter cartridge may be ejected as
it is removed. Use caution when removing.
2 Remove the protective foil from the end of the
cartridge.
3 Fillthe replacement cartridge with water from the
tap to allow for better flow from the dispenser
immediately after installation.
Lining up the arrow on the
cartridge and the cartridge
holder, slowly rotate the
cartridge clockwise until it
stops. When the cartridge is
properly installed, you will feel
it "click" as it locks into place.
I
Do not overtighten.
11

Advertisement

loading