GE Appliances GFD5140 Owner's Manual page 23

Before you call for service... GEAppliancesc
Q roubleshooting Tips
Save time and money! Review the charts on the following pages,
_ or visit GEAppliances.com You may not need to call for service.
PROBLEM Possible Causes What To Do
Dryer shakes or Some shaking/noise is normal. • Hove dryer to an even floor space, or adjust leveling legs
makes noise Dryer may be sitting unevenly as necessary until even.
Clothes take too long Improper or obstructed ducting • Check the Installation Instructions to make sure
to dry the dryer venting is correct.
• Hake sure ducting is clean, free of kinks and unobstructed.
• Check to see if outside wall damper operates easily.
Improper sorting • Separate heavy items from lightweight items (generally,
a well-sorted washer load is a well-sorted dryer load).
Large loads of heavy fabrics • Large, heavy fabrics contain more moisture and take
(likebeach towels) longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
Controls improperly set • Hatch control settings to the load you are drying.
Lint filter is full • Clean lint filter before every load.
Blown fuses or tripped circuit • Replacefuses or reset circuit breakers. Since most
breaker dryers use 2 fuses/breakers, make sure both are
operating.
Overloading/combining loads • Do not put more than one washer load in the dryer at
a time.
Underloading • If you are drying only one or two items, add a few items
to ensure proper tumbling.
The DRVdryness level Load consists of a mixture • When combining heavy and light fabrics in a load,
was chosen but load is of heavy and light fabrics choose More Dry if you are using a sensor cycle.
still damp
Exhaust system is blocked • Inspect and clean exhaust system.
Control pads not Controls accidentally put in • PressPower.
responding service made
Controls accidentally put in • Hold the Lock button for 3 seconds to unlock the dryer.
lock mode
Controls performed an • Resetthe in-house breaker.
incorrect operation
Dryer doesn't start Control panel is "asleep" • This is normal. PressPower to activate the control panel.
Dryer is unplugged • Hake sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker • Check the building's fuse/circuit breaker box and
is tripped replace fuse or reset breaker. NOTE:Electricdryers
usetwo fuses or breakers.
Dryer was accidentally paused • If the light on the Delay Dry pad is flashing, the
when starting Delay Dry dryer is paused. PressStart to restart the countdown.
No numbers displayed
during cycle,only lights
Dryer is continuously
monitoring the amount of
moisture in the clothes
• This is normal. When the dryer sensesa low levelof
moisture in the load, the dryer will display the dry time
remaining.
23