GE Appliances GLDT690 Series Owner's Manual page 12

Caring for the dishwasher.
Cleaning the Spray Arms and the Filters (Continued)
Cleaning the Filters
For best performance and results,the filter assembly must
be cleaned once a month. The filter efficiently removes food
particles from the wash water, allowing water to be recirculated
during the cycle. Forthis reason, it isa good idea to remove the
large food particles trapped in the filter frequently by rinsingthe
main filter and cup under running water. To remove the filter
assembly, follow the 3 steps shown below. To clean the main
filter and fine filter, usea cleaning brush. The dishwasher must
never be usedwithout the filters. Improper replacement of the
filter may reduce the performance level of the appliance and
may damage dishes and utensils.
STEP 1: Turn the filter counter-clockwise and lift up.
STEP 2: Lift the main filter up
STEP 3: Lift the fine filter up
_:L .J
General Care Instructions
Protect Against Freezing
If your dishwasher is left in an unheated
place during the winter, ask a service
technician to:
r_cut off electricalpower to the dishwasher.
Removefusesor trip circuit breaker.
r2lTurn off the water supply and
disconnect the water inlet line from
the water valve.
r_ Drain water from the water inlet line
and water valve. (Use a pan to catch
the water.)
E] Reconnect the water inlet line to the
water valve.
Two types of f I .;i I_1,:i[ _ I! II
airgaps 4_
,q _- t .:l_it_
, : <" .I¢
h
Check the air gap any time your
dishwasher isn't draining well.
Does Your Dishwasher Have
an Air Gap?
An air gap protects your dishwasher against
water backing up into it if a drain clogs.
The air gap is not a part of the dishwasher.
It is not
covered
by
your warranty. Not all
plumbing codes require
air gaps, so you may not have one.
The air gap is easy to clean.
r_murn off the dishwasher and lift off the
chrome cover.
I-2] Remove the plastic cap and clean with
a toothpick.
12