Connections - Panasonic TH-58PF12WK Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker
terminal (R)
Note:
Make sure that the AC
cord is locked on both the
left and right sides.
– Cable ¿ xing band
Secure any excess cables with band as required.
Note:
One ¿ xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
¿ xing band through the clip
as shown in the ¿ gure.
1
SLOT1
Optional Terminal Dual HDMI Terminals
(equivalent of Dual
Board Insert Slot
HDMI Terminal Board
(covered)
(TY-FB10HMD))
(see page 11)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
8
AC cord connection (see page 12)
– AC cord ¿ xing
1
Plug the AC cord into the display
1
unit.
Plug the AC cord until it clicks.
2 Fix the AC cord with the clamper
which is attached to the unit.
2
For the TH-58PF12WK:
Clampers are not installed to this
unit. Ensure there is suf¿ cient slack
in the AC cord and ¿ rmly bind with
the supplied cable ¿ xing band, etc.
To secure cables connected to Terminals, wrap the cable ¿ xing band around them
then pass the pointed end through the locking block, as shown in the ¿ gure.
While ensuring there is suf¿ cient slack in cables to minimize stress (especially
in the power cord), ¿ rmly bind all cables with the supplied ¿ xing band.
2
SLOT2
LAN Terminal
(see page 57)
Speaker
terminal (L)
Close
Push
until
the hook
clicks.
Open
2. Pull
off.
1. Keep the
knob
pressed.
To tighten:
Pull
AUDIO P /C /R P /C /B Y/G
R R B B
LAN COMPONENT/RGB IN
SLOT3
COMPONENT/ From EXTERNAL
RGB IN monitor terminal
Terminals on Computer
(see page 11) (see page 9)
1
2
2
Unplug the AC cord
Unplug the AC
cord pressing
the two knobs.
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet ¿ rst.
To loosen:
Push the catch
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 10)
1