Fire Alarm System - First Alert FA162C User Manual

FIRE ALARM SYSTEM (IF INSTALLED)
General
Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In
the event of an emergency, the installed smoke and heat detectors will automatically activate
you security system, triggering a loud, interrupted sound from the Keypad. An interrupted
sound will also be produced by optional exterior sounders. A FIRE message will appear at your
Keypad and remain on until you silence and clear the alarm display.
1. Should you become aware of a fire emergency before your detectors sense the problem,
In Case Of Fire
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your local Fire
4. If no flames or smoke are apparent, investigate the cause of the alarm. The zone descriptor
Silencing A Fire Alarm 1. Silence the alarm by pressing the OFF key. To clear the alarm display, enter your code and
2. If the Keypad indicates a trouble condition after the second OFF sequence, check that
3. If this does not remedy the problem, there may still be smoke in the detector. Clear it by
4. When the problem has been corrected, clear the display by entering your code and
go to your nearest Keypad and press the single panic key (or panic key pair) assigned as
FIRE emergency (if programmed by the installer) and hold down for at least 2 seconds. The
alarm will sound.
Department immediately.
of the zone(s) in an alarm condition will appear at the Keypad.
press the OFF key again.
smoke detectors are not responding to smoke or heat producing objects in their vicinity.
Should this be the case, eliminate the source of heat or smoke.
fanning the detector for about 30 seconds.
pressing the OFF key.
– 33 –