Daily Maintenance - Shindaiwa EB802 Owner's/Operator's Manual

Maintenance (continued)

Daily Maintenance

WARNING!
To reduce fire hazard, keep
the engine and muffler free of dirt,
debris, and leaves.
Prior to each workday, perform the
following:
■
Remove all dirt and debris from
blower exterior and the engine.
Check the cooling fins and air
cleaner for clogging and clean as
necessary.
Every 10 Hours
(more frequently in dusty conditions)
1. Remove the air cleaner cover by
loosening the thumbscrews and lift-
ing. See Figure 18.
2. Remove and inspect the pre-filter.
If the pre-filter is torn or otherwise
damaged, replace it with a new one.
IMPORTANT!
The blower uses a special high capac-
ity dry-type air filter element. The filter
should not be cleaned with a liquid
cleaner and must NEVER be oiled!
3. Clean the pre-filter with soap and
water. Let dry before reinstalling.
4. Inspect the air cleaner element. If
the element is damaged or distorted,
replace it with a new one.
5. Tap filter gently on a hard surface to
dislodge debris from element or use
compressed air from the inside to
blow debris out and away from the air
filter element.
14
CAUTION!
The engine is cooled by air drawn
into the air intake cover on the
blower housing. The blower fan then
pushes the cooling air through an
opening in the fan housing, forcing it
past the cylinder cooling fins. Failure
to keep the cooling system and its
passages clear of debris will likely
result in engine overheating, a major
cause of serious engine problems
that can lead to failure.
Thumbscrews
Figure 18
6. Install the filter element, pre-filter
and cover in the reverse order of
removal.
IMPORTANT!
Direct the air stream at the inside face
of the filter only!
■
Inspect the engine, tank, and hoses
for possible fuel leaks, and repair
as necessary.
■
Inspect the entire blower for loose,
damaged, or missing components,
and repair as necessary.
■
Carefully remove any accumula-
tions of dirt or debris from the
muffler and fuel tank. Dirt build-up
in these areas can lead to engine
overheating, fire or premature wear.
Air Cleaner
Element
Cover
Pre-Filter
To remove the cover, loosen the
CAUTION!
Never operate the blower if the air
cleaner assembly is damaged or
missing!
thumbscrews and lift.