Scag Power Equipment SFZ61-730FS Operator's Manual page 17

Section 4
6. Hourmeter (Figure 4-1).
hours the engine has been operated. It operates
whenever the engine is running. Has preset
maintenance reminders for engine and hydraulic
system oil changes. Will start flashing scheduled
maintenance 2 hours before preset time and
continue flashing until 2 hours after. Automatically
resets.
7. Fuse Holders (Figure 4-1).
protect the mower's electrical system. To replace
fuses, pull fuse out of the socket and install a new
fuse.
8. Left Steering Control (Figure 4-1).
the mower's left wheel when traveling forward or
reverse.
9. Right Steering Control (Figure 4-1).
control the mower's right wheel when traveling
forward or reverse.
10. Brake Pedal (Figure 4-1).
pedal applies the brake.
11. Parking Brake Lock Latch (Figure 4-1.
to lock the parking brake in the engaged position.
Fully depress the brake pedal and pull the parking
brake lock latch back to lock the parking brake in the
engaged position. See Figure 4-2. Fully depress the
brake pedal forward to disengage the parking brake
lock latch, then release the brake pedal to disengage
the brake. See Figure 4-3.
PULL BACK ON
PARKING BRAKE
LATCH
PUSH BRAKE
PEDAL FORWARD
Figure 4-2. engaging the Parking Brake
Indicates the number of
Two 20-amp fuses
Used to control
Used to
Depressing the brake
Used
PUSH BRAKE PEDAL
FORWARD THEN RELEASE
PEDAL TO DISENGAGE
Figure 4-3. Releasing the Parking Brake
12. Dump valve Control Levers (Figure 4-4).
on the left and right side of the bumper, used to
"free-wheel" the mower. Rotating the levers forward
into the notch (towards the front of the mower) allows
the unit to move under hydraulic power. Rotating the
levers backward to the notch (towards the rear of
the mower) allows the mower to be moved by hand
(free-wheeling).
DUMP VALVE
CONTROL LEVER
"DRIVE" POSITION
"FREEWHEEL" POSITION
Figure 4-4.
13. Deck Lift Foot Lever (Figure 4-1).
and lower the cutter deck.
14. Cutting Height Adjustment (Figure 4-1).
set the cutter deck at the desired cutting height.
15. Deck Release Lever (Figure 4-1).
cutter deck in the transport position. Push the foot
pedal forward and pull back on the release lever to
release the cutter deck for normal mowing.
13
Located
2012 SFZ DVL
Dump Valve Control
Used to raise
Used to
Used to lock the
R