Wireless Specifications - Samson EXPEDITION XP40i Owner's Manual

Wireless Specifications

HT5 Microphone Transmitter
Transmission Mode
Frequency Range
OSC System
RF Power
Operating Range
Frequency Stability
Approvals
Radiating Harmonic and Spurious Emission
Antenna Type
Audio Frequency Response
Pre-Emphasis
Noise Reduction System
Signal To Noise Ratio
Maximum Input Level
T.H.D.
Current Consumption
Battery Life (MN1604 9-volt alkaline)
Operating Temperature
Controls
LED Indicator
Dimensions
Weight
XP40iw Receiver
Receiving System
Frequency Range
Band A (European / UK models)
Band B (European / UK models)
Receiving Mode
Sensitivity
Selectivity
Squelch Sensitivity
Intermediate Frequency
Local Oscillator System
Noise Reduction System
De-emphasis
Signal To Noise Ratio
Audio Frequency Response
T.H.D.
Specifications are subject to change without notice.
20
Frequency modulation, 80KF3E, 15 kHz peak deviation
173.80 MHz to 213.20 MHz, 25 frequencies
20 mW (USA models), 10 mW [(2 mW ERP) European / UK models)]
Complies with ETS 300 422 and FCC Part 74
Below limits of applicable regulations
Power On/Off, Audio On/Off, Level Control (Trimpot)
173.80 MHz to 213.20 MHz, 25 frequencies
< 3 µV for 20 dB SINAD, < 10 µV for 50 dB S/N
120 kHz BW, nominal @ -6 dB, ± 300 kHz (adj CH), -75 dB
> 100 dB (IHF-A) line out, > 90 dB (IHF-A), mic out
Crystal controlled, x12 multiplication
± 10 ppm
Internal
40 Hz to 15 kHz ±3 dB
50 µSec
NE571 based compandor
> 100 dB
0 dBv (ST5), -20 dBv (VH3)
< 1% @ 1 kHz
34 mA (typical)
6 hours (typical)
-10 to +55 degrees C
Battery high/medium/low
37 (W) x 233 (H) mm (1.46 x 9.17 in.)
200 grams • 7.1 oz.
Single conversion Superheterodyne
160.10 to 177.90 MHz
189.10 to 210.10 MHz
3 µV to 250 µV adjustable
10.7 MHz
Crystal controlled
NE571 based compandor
50 µsec.
40 Hz to 15 kHz ±3 dB
< 1% @ 1 kHz
300 ft.
80KF3E