Table of Contents
Advertisement
INSTALACIÓN DEL TANQUE
Insert Tank Bracket into Slot, Rotate 90 Degrees.
Slide Down Over Tank Ring to Hold Tank in Place.
Inserte el soporte del tanque en ranura, rote 90 grados.
Resbale abajo sobre el anillo del tanque hacia el tanque del asimiento en lugar.
IMPORTANT:
assembly does not contact the casting,
or any other parts which will get hot.
IMPORTANTE:
ensamblaje de manguera no entra en
contacto con el bastidor, o ningunas
otras piezas que consigan calientes.
TANK INSTALLATION
Ensure hose
asegure el
WARNING: Before proceeding with the following
steps, ensure you have read L.P. Gas Cylinder Hose
and Regulator sections of the USE AND CARE
MANUAL. The L.P. cylinder, if supplied with your
grill, has been shipped empty for safety reasons.
The cylinder must be purged of air and filled prior
to use. Follow all directions under L.P. Gas
Cylinder Filling section of the USE AND CARE
MANUAL.
Regulator Connection Facing Front.
Frente De los Revestimientos De la
Conexión Del Regulador
10
Advertisement
Table of Contents
