Table of Contents
Advertisement
Mounting the IR Sensor
Before you mount the IR sensor, keep the following points in mind:
Connecting the IR Remote
Connect the IR remote to Quad Input Manager Module A. See the diagram in
"Unpacking and Checking Accessories" on page 17 for a visual example of this
connector location.
RS485 Quad Module Connections
Use the RS485 cables to connect the RS485 Out of each Quad Input Manager Module
to the RS485 In of the next module. The order of the modules does not matter. You
do not have to complete the loop - the RS485 In of the first module will remain
empty, as will the RS485 out of the last module. Unlike other Runco wall products,
these connections must be made, even if you will not be controlling your wall
through RS232.
• Because most menus will be controlled on the master (A1) display, it is
suggested the you mount the IR sensor near this display.
• No matter which display a menu is on, you will still need to point the remote
towards this one IR sensor that controls the entire wall.
Runco WindowWall Installation Guide
Installing LCD Tiles
41
Advertisement
Table of Contents
