Table of Contents
Advertisement
Installation
3.5
Installing Batteries in
the Remote Control
Notes on Remote Control
Operation
3.6
Turning on the Power
5. Install the safety catches at the
top rear corners of the screen.
These prevent the screen from
separating from the hinge
when the screen is opened or
closed.
a Remove the nut at one end
of the hinge wing on the
back of the screen.
b Place the safety catch on
the exposed screw shaft
where you removed the nut.
c Secure the catch using the nut that you removed in Step 5a.
d Repeat Steps 5a through 5c to install the other safety catch.
To install batteries in the remote control:
1. Slide the battery compartment cover down to remove it.
2. Install two AAA batteries with the correct polarity.
3. Replace the cover.
➤
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
1. Turn on your source components.
2. Set the main power switch on the VideoWall/CineWall to the ON position.
3. Return the strut the closed position and close the screen.
4. Gently press on the bottom left and right corners to engage the latches at the bottom
of the screen.
5. Press the ON button on the remote control to turn on the VideoWall/CineWall.
Safety
Catch
Hinge Wing
32
VideoWall™/CineWall™ Installer/Integrator Manual
Remove this nut,
install Safety Catch
and replace
Advertisement
Table of Contents
Troubleshooting
