Icom IC-2725E Instruction Manual page 49

D Memory/call➪call/memory
q Select the memory/call channel to be transferred.
➥ Push the desired band's [M/CALL•MW] several times to
select memory mode or call channel, then rotate the
same band's [DIAL] to select the desired memory or call
channel.
w Push the same band's [M/CALL•MW] for 1 sec.
• "!" indicator and "– –" indication blink, and shows VFO condi-
tions.
e Rotate the [DIAL] to select the target memory channel.
• "C1" or "C2" blinks when the call channel is selected.
• Scan edge channels, 1A/1b, 2A/2b, 3A/3b, 4A/4B, 5A/5b can
also be selected.
r Push the [M/CALL•MW] for 1 sec. to transfer the selected
memory/call channel contents to the target memory.
• The targeted memory and transferred contents are indicated.
[EXAMPLE]: Transferring memory channel 30 contents to channel 31.
Front panel operation:
Select the memory channel, then push
MAIN DUP T DUP
MAIN
T X T X
M
HM-133 operation:
Select the memory channel, push
M/CALL for 1sec. Select the target channel.
MW
T MAIN
T X
M
then push .
MEMORY OPERATION
z Select the memory/call channel to be trans-
MR/CALL
ferred.
➥ Push [MR/CALL] to select memory mode,
then select the desired memory channel
MW
via [Y]/[Z] or keypad.
➥ Push [MR/CALL] for 1 sec. then push
[Y]/[Z] to select the desired call channel.
[Y]/[Z]
x Push [FUNC], then [
• "!" indicator and "– –" indication blink, and
shows VFO conditions.
c Push [Y]/[Z] to select the target memory
channel.
• "C1" or "C2" blinks when the call channel is selected.
• Scan edge channels can also be selected.
• The keypad cannot be used for the selection.
v Push [FUNC] then push [
1 sec. to transfer the selected memory/call
channel contents to the target memory.
• The targeted memory and transferred contents
are indicated.
Push M/CALL for 1 sec.
MW
M
Push then push
5
A(MW)] momentarily.
CLR
A(MW)] for
CLR
MAIN DUP T
T X
M
for 1 sec.
5
32