How To Delete A Channel; Pc Programmable Features - Ritron Display JBS-146D Owner's Manual

HOW TO DELETE A CHANNEL

Following the instructions in "How to Field Program Frequency &
Tone Codes" on page 13, enter a Frequency Code of "00" and a
Tone Code of "00". Once a channel has been deleted it is no longer
available with the Channel Selector.
A deleted channel can be added back at any time. To add a deleted
channel back, follow the instructions in "How to Field Program
Frequency & Tone Codes" on page 13.

PC PROGRAMMABLE FEATURES

The "Display Series" base station has many features that are only
available through PC programming. See your Ritron dealer or
contact Ritron directly for PC programming of these options.
Receive and Transmit Frequency on any channel can be
programmed to any valid frequency within its designated band. (See
"Display Series Model Numbers" for frequency bands)
Squelch Tightener on any channel can adjust carrier squelch UP to
block distant signals or DOWN to hear more distant signals.
Wide or Narrow Band transmit operation can be set per channel.
Refer to the section FCC Narrowband Mandate to see if your radio is
capable of wideband transmit operation.
Monitor Lock Out can be set on any channel to prevent monitoring
of the channel, only broadcasts with the correct QC or DQC code
can be heard.
Transmit Inhibit on Busy Channel can be set on any channel to
prevent transmitting when a broadcast is present on the receiver that
does not carry the correct code. This feature is usually used in
conjunction with Monitor Lock Out.
Transmit Time Out time can be changed.
Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at
RADIO PROGRAMMING
Power Saver "sleep" time can be set, or power saver can be
disabled.
Courtesy Beep sounds a short tone at the end of each received
transmission to indicate that the channel is clear and you may
transmit.
Transmit Clear To Talk Beep Any channel can be set to sound a
short tone after the PTT has been pressed to indicate that the base
station is ready for you to begin talking.
Disable Field Programming to allow only PC programming.
Channel Scan can be programmed or edited to include any of the
radio channels, even channels that are not selected with the
Channel Selector button. Other programmable scan features include
scan resume delay time, busy channel blocking, last active channel
beeps, and priority scanning options.
2-Tone Paging Decode can be set on any channel. Programmable
options include the setting of the 2-Tone frequencies and duration,
All Call, Group Call, Call Transpond, automatic setting of 2-Tone
Decode when the channel is selected, automatic reset of the 2-Tone
Decode if a call is not answered within 15 seconds, and
automatically set the base station to carrier squelch mode after a 2-
Tone signal is received.
* 2-Tone Encode Each channel can be programmed with a unique
pair of 2-Tone encode frequencies between 300-1500 Hz. Pressing
the "Z" button will send the 2-Tone Code.
* DTMF ANI A unique DTMF ANI string can be programmed
separately for each channel. Pressing the "Z" button will send the
DTMF ANI.
* Note: A channel can not be programmed to do both DTMF ANI
and 2-Tone Encode.
www.ritron.com page 16