RIDGID R82233 Operator's Manual page 14

OPERATION
WARNING:
Do not drive a screw where there is likely to be
hidden wiring behind the surface. Contact with a
"live" wire will make exposed metal parts of the tool
"live" and shock the operator. If you must drive a
screw where hidden wire may be present, always
hold tool by insulated gripping surfaces (handle)
when performing the operation to prevent a shock
to the operator, as seen in figure 8.
CAUTION:
The impact driver is not designed to be used as
a drill.
DRIVING OR REMOVING SCREWS
See Figure 8.
 Place the direction of rotation selector in the correct
position for the operation.
 Hold the impact driver with one hand.
 Place the bit on the screw head and slowly depress the
paddle switch. Start the bit slowly for more control.
 As screw is driven, impacting will begin.
RIGHT ANGLE DESIGN
See Figures 9 - 10.
The impact driver features a right angle head design to reach
into tight areas.
RIGHT
Fig. 8
14
WRONG
Fig. 9
Fig. 10