Engine Oil Recommendations - Honda Marine BF75D Owner's Manual

4. Clean the oil filter mounting base,
and coat the rubber seal of the new
oil filter with clean engine oil.
Use only a Honda Genuine oil
f ilter or a f ilter of equivalent
quality specif ied f or your model.
Using the wrong f ilter, or a non-
Honda f ilter which is not of
equivalent quality, may cause
engine damage.
5. Screw on the new filter by hand
until it contacts the engine, then
use a suitable tool to tighten the
filter an additional 7/8 turn.
OIL FILTER TIGHTENING
TORQUE:
9 lbf·ft (12 N·m , 1.2 kgf·m)
6. Return the outboard motor to the
vertical position, and fill the
crankcase with the specified
amount of the recommended oil.
SERVICING YOUR OUTBOARD MOTOR
7. Start the engine and check for
leaks (be sure the water level is at
least 2 inches (5 cm) above the
antiventilation plate).
If you are changing the oil filter
while the outboard motor is out of
the water, use commercially
available ear muffs and water hose
to supply water.
Running the outboard motor
without suf f icient cooling water
will damage the water pump and
overheat the engine.
8. Stop the engine, and check the oil
level as described on page
necessary, add oil to bring the oil
level to the upper limit mark on the
dipstick.

Engine Oil Recommendations

Oil is a major factor affecting
performance and service life. Use
4-stroke detergent oil.
SAE Viscosity Grade
AMBIENT TEMPERATURE
Honda 10W-30 FC-W outboard
motor oil is recommended for
general use.
88 . If FC-W is a registered trademark of
the National Marine Manufacturers
Association.
If Honda 10W-30 FC-W oil is not
available, Honda recommends that
you use API service category SG, SH
or SJ oil. The SAE oil viscosity and
service category are in the API label
on the oil container.
91